Filling a bottle means delivering an appropriate quantity, but also ensuring that the product, the packaging, the label and the batch number correspond to the expected product reference. Insufficient control can produce units with the wrong volume or the wrong label, even when the formula is correct. Control of filling is therefore a matter of process and traceability.

Prepare the line before the first bottle

Confirm the condition and cleanliness of the equipment, the formula to be filled, the format, the authorised components, the coding and the settings. The checks at start-up, during the batch and at the end of the operation must be adapted to the risk and to the applicable regulations. The samples checked, the deviations and the corrections are recorded. Numerical thresholds must come from validated procedures, not from a generic rule copied from a blog.

Managing changeovers without mixing up product references

Switching from a face cream to a body lotion, or from one fragrance to another, requires a controlled changeover procedure. Remaining components, labels and products must be removed or correctly identified. The expected result is simple: being able to explain which units were produced, with which components, at what time and under which batch.

Useful table: initial check, periodic check, decision in the event of a deviation and the corresponding batch record.

Points to approve in your file

For each of the following elements, write down the decision taken, the person who approves it and the document that can justify it:

  • Reference.
  • Setting.
  • Quantity.
  • Coding.
  • In-process control.
  • Run changeover.
Operator in laboratory clothing at the line's control panel

Frequently asked question

Can filling be validated by weighing only the first bottle?

No. The checks must correspond to the risk and the process, especially during the run and at changeovers. The control plan and the applicable tolerances must be defined and documented.

Apply this guide to your project

To apply this guide, document two elements first: the reference and the setting. If an industrial study is needed, specify the products, indicative volumes, packaging and countries of sale concerned. The BIOCYLAB team can examine this information according to the actual scope of the project; quantities, lead times and services must be confirmed before any decision.

Reference sources

Request a quote