A 20-litre format can be relevant for small-scale repackaging, a spa or a commercial trial, but its value depends on the density and the final packaging. For a product with a density close to that of water and 200 ml bottles, the theoretical calculation gives one hundred fills; transfer losses and operating margins must then be deducted. This figure is a volume illustration, not a promise of yield.

The choice of industrial container matters

The can must be suited to the formula, its viscosity and the storage conditions. Check the closure, integrity, opening, method of dispensing, cleanliness, traceability and material compatibility. A product sensitive to air or hard to pump may require a different procedure from a fluid shower gel. The buyer must also know whether the supplier delivers a formulation ready to fill or a product requiring an additional step.

Prepare a useful price request

Indicate the desired formula, the volume, the country of delivery, the order frequency, the type of container and the end use: treatment room, refill or sale under a brand. Also ask for the batch documents, the period of use of the bulk after opening where it is substantiated and the transport conditions. The quote becomes more comparable when these parameters are explicit.

Key point: 20 litres is a logistics format, not a guarantee of cost, compliance or yield in bottles.

Open shipping carton with products wedged in its compartment

Points to approve in your file

For each of the following elements, write down the decision taken, the person who approves it and the document that can justify it:

  • Density.
  • Actual volume.
  • Losses.
  • Container.
  • Preservation.
  • Delivery frequency.

Frequently asked question

How many 200 ml bottles come out of 20 litres?

The purely volumetric calculation gives 100 bottles of 200 ml. The actual yield is lower or different depending on losses, filling tolerances and the process; it must be measured on the line.

Apply this guide to your project

To apply this guide, document two elements first: the density and the actual volume. If an industrial study is needed, specify the products, indicative volumes, packaging and countries of sale concerned. The BIOCYLAB team can examine this information according to the actual scope of the project; quantities, lead times and services must be confirmed before any decision.

Request a quote